Once a saw is setup, it can be transferred between both guides very easily and without fuss.Ĭan arrange shipping for additional cost. Alternatively, replacement guide strips can be purchased for $16 from Timbecon / Carbatec The alignment strips are on both sides to cater for different saws. As you setup the cut alignment by cutting through the blue plastic guide strips, this means that you will only be able to use this with the more common right-hand bladed saw. I had it set up with a left-hand bladed saw (makita DS611 if you want to double check your saw vs what I used). mostly used for rough cutting plywood sheets that exceeded the dimensions of the rip cut. The Kreg® Docking Station is the ultimate benchtop setup for your Pocket-Hole Jig 520PRO and 720 with added storage, material support wings for long pieces, and a Pocket-Hole Jig Clamp to secure the jig to your workspace. With the Rip-Cut, you can cut with the confidence you want and the precision you need.The Rip-Cut easily makes straight, accurate, repeatable cuts without measuring. Was also good for roughing out sheets before finishing on the table saw. Kreg Docking Station KPHA750 for 520/720 Pocket Jigs. The Kreg Rip-Cut turns your circular saw into a precision edge-guided cutting tool that makes straight, accurate, repeatable cuts in plywood, MDF, and other large sheets. With care it was quite accurate and could be used for repeatable, final cuts. Was great for cutting plywood sheets on the floor that were too big to run through the table saw.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |